STANDARD TERMS AND CONDITIONS
Every Quote is subject to our standard terms and conditions. By accepting the quote, you are agreeing that you have fully read and understood the contents of our terms and conditions.
A 65% deposit is payable on acceptance of this quotation, 25% on delivery of units to site – the balance and any other applicable charges are due on completion should CLITE be responsible for installation.
There will be a 2.5% surcharge made on all cash deposits and credit card payments.
Products and/or installation service below R8000 are to be paid in full on confirmation of your acceptance of the quote.
No payments will be subject to a draw from your financial institution, approval by an architect, other professionals, an occupation certificate from Local Council or for any other reason whatsoever unless agreed to in writing by both parties on acceptance of this agreement.
A 65% Deposit will also be required on any and all additional work required after this quotation is accepted.
Unless expressly agreed otherwise all invoices are due and payable within 3 days of invoice date. Should payment not be received within the 3 days lead time, work will stop immediately until payment reflects.
No retention, nor penalties, will be accepted.
Final payment is due on practical completion (The stage of completion where the works or a section thereof is substantially complete and can effectively be used for the purposes intended). All our work is guaranteed and any snags will fall under the guarantee.
If you don’t pay on time, we can cancel our contract or suspend delivery or installation, until you have paid the outstanding amounts. Interest at our banker’s prime lending rate will be charged on late payment from date of default until paid in full. No Guarantees will be applicable unless all monies are paid in full.
No Deposit will be refunded in the event of a cancellation or any delays which may occur through no fault of CLITE.
All products manufactured, delivered and/or installed shall remain, in total, the sole property of CLITE Fitment Solutions until paid for in full.
Payment of order deposit is acceptance of offer.
Product Size and Aperture Preparation
The quotation is based upon the sizes of product quoted, and the preparation of apertures is the responsibility of the Client.
The apertures of the building will be pre-measured before manufacturing commences.
The units ordered herein are made to measure and once units have been manufactured, it cannot be cancelled or varied in any manner whatsoever. Should changes be required, the Client undertakes to pay for all costs already incurred by CLITE in the execution of this order whether fully or partially completed.
Whilst every endeavour is made to ensure the accuracy of our quotations we accept no liability for errors or omissions which may be found to have occurred. The Client is advised to carefully study the quotation to establish the accuracy thereof.
Any changes to the quote will be in writing, No verbal changes to the quote will be accepted and if so, CLITE will not be held responsible for any errors.
A Lead time of +/- 15 -21 working days is to be allowed to manufacture standard items of stock. Special items or colours could take longer, or as advised by CLITE. Lead time on quote must be adhere to. There are times because of conditions out of our control lead time may be dictated by unforseen events (power failures, weather conditions not be able to transport cupboards etc)
Powder Coating & Anodising of special colours +/-15 working days, Client to provide correct colour code or sample.
This quotation is subject to the express condition that CLITE shall in no way be liable for any consequential loss,
damage or delay to the customer arising from an Act of God, Act of State, breakdown of equipment, labour dispute, war, riot civil commotion, transport delay or any other causes beyond the control of CLITE Fitment Solutions.
Wrap Doors and profile sides (wrap, duco, etc)
Due to the nature of wrap, especially on solid colours, colour variances may occur when acquiring wrap doors. C LITE will not remanufacture, or be held liable for any colour differences in foil where goods were ordered on different dates, or manufactured in different batches. Differences in duco coats also apply to the above.
Granite and Engineered Stone
Granite is a natural porous product. Generally, any liquid spilled on a granite top, if wiped up within a few minutes, will not stain. However, even water can soak into a granite countertop and leave a dark coloured spot but this will evaporate in minutes. Liquids that do not evaporate, such as oils and wine will cause stains if left to soak into the stone. For the longevity of your granite we will suggest applying a penetrating sealer (available from most hardware stores and granite suppliers). Routine cleaning of your countertops with mild soap and water is all that is generally required. Once every 4 years, a re-application of a penetrating sealer should be performed, which only takes about 15 minutes.
Engineered stone (Quartz & resin product) will keep their enduring lustre and beauty for years to come, with minimal effort. Warm water and a splash of mild detergent is all that’s required - there’s no need to wax or seal. It’s important to be aware that like any other surface, it can be permanently damaged if exposed to strong chemicals and solvents that can damage its physical properties. Never clean surface with products that contain
Trichlorethane or Methylene chloride. Avoid the use of highly aggressive cleaning agents such as oven/grill cleaners and dishwasher polishing agents that have high alkaline/pH levels (pH 8.5 or higher). Products containing oils or powders may leave a residue and should be rinsed off thoroughly. Should your surface accidentally be exposed to any of these damaging products, rinse immediately with clean water to neutralize the effect. See warranty info on your specific product on their website.
C Lite will not be held responsible i.r.o. problems not reported within 24 hours from installation. Any client-attorney costs which may arise from this order will be paid by the client. Interest will be charged at prime rate plus 5%. It is agreed that C Lite may use any photos taken of the work done for advertising purposes.
Goods delivered with protection will be deemed to be in good condition.
The risk in and to the goods sold and delivered by CLITE to the Client shall pass to the Client upon delivery.
Once goods are delivered CLITE accepts no liability should damage occur. CLITE Fitment Solutions will not be responsible for any loss, theft or damage to existing property or personnel injuries.
Should site conditions delay installation, CLITE reserves the right to be compensated for any additional expenses which may be incurred. If our installation teams are required to work according to Clients time schedule, “split installations” a new installation date will have to be rescheduled. All outstanding monies to be settled immediately.
Should our site commencement date exceed 2 months from date of appointment, we reserve the right to amend the material prices according to any increases received from our suppliers.
Duration of installation will vary depending on the status of the building once work commences.
After hours and weekend installation will be charged additional if Client insists installation to proceed after hours.
We will take care when installing our products, we will not be liable for damage caused to your property in the process, unless caused wilfully. For example;
- tiles almost certainly will break (aluminium doors and where chisel works are done,
- plaster will be damaged while removing existing windows & doors.
- dust will be present and is unavoidable while working.
- It’s difficult to work over/ between plant beds and not damage any plants.
CLITE will not guarantee waterproofing for any Sliding door or Vista fold tracks being put “on top of tiles”.
We will not be held responsible for floors that are not level. Any adjustments or cutting of doors will be for Clients account.
CLITE will supply access ladders up to 2.5m. Access equipment (scaffolding, hoists, etc.), would be an extra if required.
The appointment of a safety representative and safety files are excluded from this quote.
Client has the choice to leave protection on and clean himself or to ask us to clean while we are on site. Any call outs for cleaning and removal of protection will be charged for.
Whilst we will endeavour to meet the required installation date, such date shall not constitute a material term of this contract and any failure to adhere to such proposed date shall not entitle the Client to cancel this contract or to relieve him from his strict performance of all his obligations.
Once your project is complete, you will be notified and we require that you inform us of any concerns or snags within 48hours, or we will assume you are 100% satisfied.
This quote excludes all or any building, plastering, painting and tile work.
Normal cornice exclusion of cupboards extending to ceilings unless specified in quote as included.
We can arrange removal of waste material from the site, at additional cost to you.
This quotation specifically excludes sandblasting, night-latches, cabin hooks, burglar bars, weather strips or any special ironmongery unless so specified in writing.
Flush bolts do not fall under our guarantee. If broken flush bolts are assessed to have been damaged due to mishandling, they will be charged for.
Acceptance of Quote
Our Standard Terms and Conditions will apply once we received a 65% deposit.
All quotations are compiled based upon the information and specifications provided by yourself (or your professional consultants)
Notwithstanding the terms of an accepted quotation, should the information, specification or any other relevant factors leading to a quotation be materially altered at any time, CLITE may include the costs and fees related to such alteration in its interim and final invoices.
The client confirms that they have read all above conditions, and have accepted such. This quote remains valid for 15 working days, thereafter may then become subject to material price increases.
Ownership of Goods
Goods remain the property of C Lite Home Solutions until paid for in full.
C Lite retains the right to dispose of goods, not paid for in full and/or collected, within 6 months after execution of an order.
WE WILL BE CHARGING OUR CUSTOMERS FOR THE BANK FEES RELATING TO CASH/CHEQUE OR FOREIGN DEPOSITS. THIS IS DUE TO EXCESSIVE BANK CHARGES ON ALL SUCH DEPOSITS!
We reserve the right to change these terms and conditions from time to time in our sole discretion. In the event of any violation of these Terms and Conditions, we reserve the right to seek any and all remedies available, whether by law or in equity.